$13.99
In stock. Available at: Petsmart
Store Rating
Merchant Reviews
Write Review

Rapidly removes phosphate and silicate from marine and freshwater aquariums. Rapidly removes phosphate and silicate from marine and freshwater aquariums. It is not recommended for phosphate buffered freshwater. PhosGuard is highly porous for high capacity and bead-shaped for optimum water flow. It outperforms all competing products. 500 mL easily treats over 150 gallons.For best results, PhosGuard should be placed so as to maximize the flow of water through it. It may be used in a canister filter, box filter, or any high flow area of a trickle filter. In some situations it may be necessary to use in a filter bag.Use 250 mL (about 1 cup) for every 300 L (75 gallon). 1 L treats up to 300 gallons. Leave product in place for 4 days, then test phosphate or silicate concentrations. If the concentration of the component you are trying to decrease has not dropped to around 0.02 mg/L, then replace the PhosGuard, otherwise leave in place until levels begin to climb again. As long as concentrations remain under control, the product is not exhausted.Each 500 mL of PhosGuard treats over 600 L (150 gallons) (i.e. will remove up to 30 mg/L phosphate in 600 L (100 gallons) of water, depending on the initial phosphate/silicate concentrations and the current biological load. Over treating is not recommended.PhosGuard is not an exchange resin, it does not release anything into the water. It does not leach phosphate or silicate back into the water and may be removed, dried, and returned to service until exhausted. Continuous use of small quantities is better than intermittent use of larger quantities.Caution! May generate heat on initial contact with water. Pre-wet by adding to a double volume of freshwater (e.g. 250 mL of product in 500 mL water), followed by a rinse.

Product Rating
Read product user reviews
Write a review: You could win $100

In Stock